Konica Minolta bizhub C650 Service Manual page 844

Field Service Ver. 8.0 Jun. 2008
9. Touch [State Confirmation] → [Memory/HDD Adj.] → [HDD Format] → [Logical For-
mat].
10. Check to see that the Start key is lit in blue. Touch the Start key to initiate Logical For-
mat.
11. Turn OFF and ON the main power switch and sub power switch.
G. Upgrade to the function enhancement 3 from the early mass-production firmware
4
(1) HDD Version Up (LK)
1. After rewriting the firmware, turn OFF and ON the main power switch and sub power
switch.
2. Trouble code C-E002 is displayed.
3. Call the Service Mode to the screen.
4. Touch [State Confirmation] → [Memory/HDD Adj.] → [HDD Version Up (LK)].
5. Check to see that the Start key is lit in blue. Touch the Start key to initiate version up.
6. When version up is completed, the result is displayed on the screen.
7. Turn OFF and ON the main power switch and sub power switch.
(2) Conversion Up (bizhub C550/C451 only)
1. Trouble code C-CC00 is displayed.
2. Call the Service Mode to the screen.
3. Touch [State Confirmation] → [Memory/HDD Adj.] → [↓] → [Conversion Up].
4. Check to see that the Start key is lit in blue. Touch the Start key to initiate Conversion
Up.
5. When Conversion Up is completed, the result is displayed on the screen.
6. Turn OFF and ON the main power switch and sub power switch.
(3) XPS Enable Format (bizhub C550/C451 only)
• After completing Conversion Up, take the following steps if XPS Enable Format needs to
be performed.
1. Call the Service Mode to the screen.
2. Touch [State Confirmation] → [Memory/HDD Adj.] → [↓] → [XPS Enable Format].
3. Check to see that the Start key is lit in blue. Touch the Start key to initiate XPS Enable
Format.
4. When XPS Enable Format is completed, the result is displayed on the screen.
5. Turn OFF and ON the main power switch and sub power switch.
H. Upgrade to the function enhancement 3 from the function enhancement 1 or 2
4
(1) HDD Version Up (LK)
1. After rewriting the firmware, turn OFF and ON the main power switch and sub power
switch.
2. Trouble code C-E002 is displayed.
3. Call the Service Mode to the screen.
4. Touch [State Confirmation] → [Memory/HDD Adj.] → [HDD Version Up (LK)].
5. Check to see that the Start key is lit in blue. Touch the Start key to initiate version up.
6. When version up is completed, the result is displayed on the screen.
7. Turn OFF and ON the main power switch and sub power switch.
3. Firmware upgrade
7
4