Punch Horizontal Position; Punch Edge Detection - Konica Minolta bizhub C650 Service Manual

Field Service Ver. 1.0 Feb. 2007
6.1.2

Punch Horizontal Position

Functions • Adjusts the horizontal position of the punch holes.
Use • To change the horizontal position of the punch holes.
• Make a copy in the punch mode and make an adjustment so that the width B is within
the following range.
Adjustment
Specifica-
tion
• Specifications: B=10.5 mm
• Adjustment range: -5.0 mm to +5.0 mm (1 step=0.1 mm)
Adjustment • To make width B greater : Enter the value of [+]
instructions • To make width a smaller : Enter the value of [-]
1. Call the Service Mode to the screen.
2. Touch [Finisher].
3. Touch [FS-FN adjustment].
4. Touch [Punch Horizontal Position].
Setting/ 5. Touch [Main body].
procedure 6. Set the correction value using the [+]/[-] keys.
7. Touch [OK] twice to return.
8. Touch [Exit] on the Service Mode screen.
9. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
10.Make a copy and check the punch hole positions again.
6.1.3

Punch edge detection

Functions • Adjusts the sensitivity (light intensity) of the paper size detect board of the punch kit.
Use • This adjustment is made at the time of setup.
1. Call the Service Mode to the screen.
2. Touch [Finisher].
3. Touch [FS-FN adjustment].
4. Touch [Punch edge detection].
Adjustment 5. Touch Start key.
Specifica- 6. Confirm that the result is OK.
tion NOTE
• When NG appears, check whether the punch kit is properly installed.
7. Touch [OK] twice to return.
8. Touch [Exit] on the Service Mode screen.
9. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
B
A04EF3C501DA
6. Finisher
13