Field Service Ver. 4.0 Jan. 2008
3.4.13
Height and angle adjustment of stand table
1
1
[1]
[1]
1
[1]
X
A01GF2C515DA
[1]
A01GF2C566DA
A01GF2C567DA
1. Measure the width of X on front and
back side.
Specifications: 4 ± 2 mm
2. If X is out of the specified range,
remove two covers [1] from the legs
of the stand table.
3. Loosen four screws [1] (two screws
each for the left and right) and adjust
the height of the stand. Tighten the
screws again.
3. Other
29
1