Scan Caribration; Lcc Size Setting; Lct Paper Size Setting - Konica Minolta bizhub C650 Service Manual

10. Service Mode
(3) Printing on paper of nonstandard size fed from the bypass tray (AnySize mode)
7
• This function is available only when the function enhanced version 4 or later firmware is
installed.
Functions • To enable printing only by the setting made on the printer driver when printing is
Use
Setting/ 1. Touch [Software Switch Setting].
Procedure 2. Touch [Switch No.] and enter "69" with the ten-key pad.
3. Touch [BIT Assignment] and select "bit2" with [←]/[→] key.
4. Enter "0" or "1" with the 10-key pad.
5. Touch [Fix].
10.9.7

Scan Caribration

Functions • To set whether to use the calibration adjustment value set prior to the shipping.
Use • To be used when CCD unit has been changed.
• The original calibration adjustment value can be disabled to address image failure
Setting/ • The default setting is ON.
Procedure
NOTE
• When the setting is changed, the function becomes available by turning the
10.9.8

LCC Size Setting

Functions • To set the paper size for the LCC.
Use • Use to change the paper size for the LCC (tray 3/4).
Setting/ • The default setting depends on the setting made for the applicable marketing area.
Procedure
10.9.9

LCT Paper Size Setting

Functions • To set the paper size for the LCT.
Use • Use to change the paper size for the LCT (LU-301).
Setting/ • The default setting depends on the setting made for the applicable marketing area.
Procedure
498
7
attempted on paper of nonstandard size fed by way of the bypass tray (the default
setting is the conventional operation).
bit0-0: Conventional operation
bit0-1: The print cycle is initiated for the paper specified on the printer driver
regardless of the bypass tray paper setting.
After replacing the CCD unit, the default value needs to be set since the calibration
value set for each unit changes to control the differences in reading performance on
each scanner (CCD).
and other problems caused by individual CCD performance difference.
"ON"
sub power switch OFF and ON again.
1
A4 B5 8 /
2
A4
Field Service Ver. 8.0 Jun. 2008
x 11 16K A5
OFF
1 1
5 / x 8 / Post. S
2 2
8 1 / x 11
2