Konica Minolta bizhub C650 Service Manual page 1187

8. Mechanical adjustment
4. Remove the finisher.
See P.31
5. Open the front door.
[1]
[1]
[2]
[3]
[1]
[3]
10. Make another copy in the staple mode and check the staple position.
11. Until the staple position is within the specified range, repeat step 4 to step 10.
90
A07RF2C506DA
[1]
A07RF2C507DA
[2]
[1]
A07RF3C551DA
Field Service Ver. 7.0 Jun. 2008
6. Pull out the stacker unit [1].
7. Remove two screws [1] from the rail
stopper, and then pull out the stacker
unit [2] further.
NOTE
• Place something [3] on which the
stacker unit can rest.
8. Loosen four adjustment screws [1]
that secure the flat-stapling stoppers
/Fr, /Rr. Loosen two adjustment
screws [2] that secure the assist
stoppers /Fr, /Rr. Adjust each posi-
tion of the flat-stapling stoppers /Fr, /
Rr and assist stoppers /Fr, /Rr.
NOTE
• The heights of the four stoppers
should be same.
9. Loosen the adjusting screw [3] on
the rigid stopper, and then adjust the
its position to make the height differ-
ence with the other stoppers be 0 to -
0.5 mm.