1St Folding Skew Adjustment - Konica Minolta bizhub C650 Service Manual

Field Service Ver. 2.0 May 2008
6.2

1st folding skew adjustment

• Conduct the 1st folding skew adjustment when the skew of the 1st folding is not within
the standard value.
NOTE
• This adjustment affects the 1st Z-fold position. Be sure therefore to perform [1st Z-
fold Position] of the service mode whenever this adjustment has been completed.
See P.34
1. Remove the upper cover.
See P.11
a
3. Open the front door, and pull out the Z folding/conveyance unit.
[2]
[1]
A07TF3C505DA
[1]
A07TF2C014DA
6. Mechanical adjustment
2. Perform the Z-folding printing opera-
tion on A3 or 11 x 17 paper and
check to see if the skew of the 1st
folding is within the standard value
"a".
Standard value: a = 2 mm or less
When the value is not within the
standard value, perform the following
procedure.
4. Remove four screws [1], and remove
the conveyance upper cover [2].
39