License Settings; Banner Printing (Bizhub C451 Only) - Konica Minolta bizhub C650 Service Manual

8. Utility Mode
8.6.11

License Settings

• This is displayed only when the function enhanced version 3 or later firmware is installed.
A. Get Request Code
Functions • To display and print a request code and serial number used to activate i-Option.
Use • Used to confirm the request code and serial number.
Setting/ 1. Touch [Get Request Code], and [Yes].
Procedure 2. A serial number and request code are issued.
3. By touching [Print], the serial number and request code are printable.
B. Install License
• This is displayed only when the additional memory included in the optional upgrade kit
UK-201 is installed.
Functions • To allow administrator to activate functions provided by i-Option.
Use • Used when administrator activates functions provided by i-Option.
• By selecting a desired function and entering the corresponding license code, the
• By making settings in [Service Mode] → [Billing Setting], CE can also activate func-
Setting/ 1. Touch [Install License].
Procedure 2. Touch [Select Function].
3. Select i-Option function to be activated, and touch [Yes].
4. Touch [OK].
5. Touch [License Code].
6. Enter the license code that was issued in the license management server using the
7. Touch [Install] key.
8. Confirm the message, select [Yes], and touch [OK].
9. Turn OFF and ON the main power switch.
C. List of Enabled Functions
• This is displayed only when the additional memory included in the optional upgrade kit
UK-201 is mounted.
Functions • To display currently activated functions.
Use • Used to check the functions that are activated now.
8.7

Banner Printing (bizhub C451 only)

• It will not be displayed when the optional finisher FS-517/608 is mounted.
• It will not be displayed when the following setting shows that vendor is mounted.
5
[Service Mode] → [Billing Setting] → [Management Function Choice]
Functions • To shift to the banner printing mode.
Use • To use when printing on the long size paper.
Setting/ 1. Set the long size paper to the bypass tray.
Procedure 2. Touch [Banner Printing], and touch [ON].
3. Send the job for the long paper print.
4. Touch [Finish] to finish banner printing mode.
NOTE
• Only PC print is available for the long paper print.
• Normal job cannot be accepted during banner printing mode.
430
5
function can be activated.
tions provided by i-Option.
key board on the control panel, and touch [OK].
Field Service Ver. 8.0 Jun. 2008