Konica Minolta bizhub C650 Service Manual page 621

14. Mechanical adjustment
5. Insert paper of the size to be placed in the tray, and set the paper guide plate (front)
against the edge of the paper.
Gap between paper and the paper guide plate (front):0 < 1mm
6. Secure the front side of the paper guide plate (front) with two screws, remove the paper
and secure the back side with two screws.
7. Align the end guide plate with the marking on the bottom and secure it.
8. Select the tray where paper size needs to be changed and change paper size in the fol-
lowing screen.
[Service Mode] → [System 2] → [LCC Size Setting]
See P.498
9. Make a test print.
14.2.2 Skew adjustment of the tray 1/2
1
This adjustment must be made in the following case:
• To reduce paper skew that cannot be corrected by the registration loop adjust-
ment when the tray 1 or 2 is within the specifications.
1. Pull out the tray where this adjustment is made.
[1]
568
1
4. Align the paper guide plate (rear)
To set B5/8.5/16K sizes:
• Insert the paper guide plate (rear)
into the hole. Align it with the back
marking and secure it.
To set A5/Post card size:
• Insert the paper guide plate (rear)
into the hole. Align it with the front
A00JF2C403DA
marking and secure it.
2. Load the tray with the paper.
3. Move the set of the paper guides [1]
A00KF3C516DA
Field Service Ver. 8.0 Jun. 2008
with the marking on the bottom and
secure it with four screws.
until no gap is produced between the
both ends of paper and the paper
guides.