Konica Minolta bizhub C650 Service Manual page 606

Field Service Ver. 8.0 Jun. 2008
C. Authentication Device 2
4
Functions • To set whether or not the authentication device 2 is installed.
Use • Set when the authentication unit (biometric type or card type) is mounted.
Biometrics : Uses biometrics (finger vein) authentication system
Card 1
Card 2
• When selecting biometrics, set a film timeout interval.
• When selecting [Card 1] or [Card 2], a response timeout interval is displayed.
(The interval is unchangeable.)
• When the setting is set to Card 2, the main power switch must be turned OFF and
ON to let the new setting take effect.
• Selecting Card 2, a loadable device driver allows to install.
Setting/ <Authentication Mode>
Procedure
(1) Installing method of the loadable device driver
4
• The firmware is updated using the compact flash.
NOTE
• NEVER remove or insert the compact flash card with the machine power turned
ON.
1. Prepare a compact flash on which the driver data of the loadable device to be used was
written.
2. Turn OFF the main power switch.
3. Remove the interface cover.
See P.115
: Uses IC card authentication system
: Uses loadable device card authentication system
Card 1
[2]
[1]
A00JF2C059DA
Card 2
4. Remove the screw [1] and the metal
blanking plate [2].
12. Billing Setting
Biometrics
553
4