Shift Position Adjustment - Konica Minolta bizhub C650 Service Manual

Field Service Ver. 7.0 Jun. 2008
8.2

Shift position adjustment

• Adjust the amount of shift between copy sets ejected to the finishing tray 1.
1. Remove the upper cover/1.
See P.25
2. Remove the upper cover/2.
See P.25
3. Turn ON the main power switch and perform [M2(roller shift)HP search] in the service
mode.
See P.68
4. Turn OFF the main power switch.
[3]
[2]
[3]
[2]
[3]
[1]
A07RF3C530DA
[1]
A07RF3C531DA
8. Mechanical adjustment
5. Both in the home position and the
shift position, check to see if the
edge of the actuator [3] of the slide
gear is in the notch [2] of the slide
stay [1] of the shift unit.
6. When the edge of the actuator [3] is
in the notch [2] of the slide stay, per-
form the following adjustment.
7. Loosen the screw [2] on the mount-
ing plate [1] of the shift roller home
sensor, and then adjust the position
of the mounting plate [1] by referring
to the markings [3].
8. After completing the adjustment,
tighten the screw [2].
77