Load Data - Konica Minolta bizhub C650 Service Manual

7. Finisher
Finisher check 3
Finisher check 4
4
7.1.6

Load Data

• Register or call values adjusted for the finisher when it was shipped from the factory or
when it was installed at the customer site.
1. Call the Service Mode to the screen.
See P.434 of the main body service manual.
2. Touch [Finisher].
3. Touch [FS-FN adjustment].
70
4
Mode
SD5/bypass solenoid: ON
SD6(DN solenoid)
SD51(rewinding solenoid)
SD7/8 (flat shutting stopper release solenoid) ON
M21 (sub-tray output) line velocity
M12 (gate drive)HP search
M51 (rewinding drive) normal rotation(direction of stack)
M302 (swing drive) HP search
M302 (swing drive) edge detection sensor control
M301 (punch drive) HP search
M301 (punch drive) punch performance (two holes)
M301 (punch drive) punch (3/4 hole)
M203 (cover sheet transportation) 667mm/s line velocity
MC201 (upper paper feed clutch) ON
MC202 (lower paper feed clutch) ON
M201 (Upper rise descent) Down (HP search)
M201 (Upper rise descent) Up
M202 (Lower rise descent) Down (HP search)
M202 (Lower rise descent) Up
SD202 (upper row move solenoid) ON
SD203 (the lower move solenoid) ON
MC203 (resist transportation clutch) ON
M201 transportation M F rotation (1000mm/s)
RU Fan Motor Drive
Field Service Ver. 7.0 Jun. 2008