Konica Minolta bizhub C650 Service Manual page 624

Field Service Ver. 8.0 Jun. 2008
[1]
[1]
14.2.5 Pick-up roller load adjustment of the tray 3/4
1
This adjustment must be made in the following case:
• In case a no feed jam occurs frequently.
1. Pull out the tray where this adjustment is made.
[1]
A00JF3C006DA
[2]
A00JF3C007DA
[1]
A00KF3C514DA
14. Mechanical adjustment
4. Loosen ten screws [1].
5. Move the paper guide [1] complete
according to the amount of the mis-
centering you checked in step 1 and
adjust the center position of it.
6. Tighten ten screws [2].
7. Make another test print and check
the amount of misalignment.
2. Remove two screws (M3 x 6 mm:
V118 0306 03) [1].
571
1