Konica Minolta bizhub C650 Service Manual page 904

Field Service Ver. 3.0 Jun. 2008
C. List of processing performed when boards of another machine are remounted
2
during board replacement procedure
• Remounting boards of machine B on machine A
Request code is not gen-
Machine A EEPROM NVRAM
Firmware of a ver-
sion earlier than
function enhanced
version 3/4
Request code is not
generated.
Request code is
generated.
Initialize Initialize
Request code is not
registered in LMS.
Request code is
generated.
Restore Restore Initialize Initialize Initialize
Request code is
registered in LMS.
*1: The following are the prerequisites;
The settings (serial number, etc.) of the i-Option machine, on which the boards are remounted, dif-
fer from those of the i-Option machine, from which the boards are removed.
Machine B
erated in machine B
(same as new board)
both
no no no
action action action
no no no
action action action
no
action
4. Troubleshooting of i-Option
Request code is gener-
ated in machine B
NVRAM EEPROM both
no no no
action action action
Initial-
Initialize Initialize
ize *1
Initial-
Initialize Initialize
ize *1
Initial-
ize *1
Remarks:
Specific cases of machine
A
• Firmware of a version
earlier than function
enhanced version 3/4
• The function enhanced
version 3/4 is mounted
on a non i-Option
machine and the
request code is not
generated.
• The function enhanced
version 3/4 is mounted
on a machine shipped
as a non i-Option
machine and the
request code is gener-
ated.
• The machine is shipped
as an i-Option machine.
23
2