Konica Minolta bizhub C650 Service Manual page 374

Field Service Ver. 8.0 Jun. 2008
• When the JS-504 is mounted.
Functions • To set the priority output tray for each application (Copy print, Printer, Fax and Print
Reports).
Use • To change the prior output tray according to the application.
Setting/ • The default settings are as follows.
Procedure Copy
Print
Report Output
Fax
(3) Bin Setting (bizhub C451 only)
• It will be displayed only when the optional mailbin kit MT-502 is mounted.
Functions • Assign the tray 1 of the finisher to the mailbin 5, and the tray 2 to the mailbin 6.
• The tray 2 can be assigned when the optional exit tray OT-602 is mounted.
Use • Use when assigning the tray 1 and the tray 2 of the finisher to the mailbins.
Setting/ • The default setting is Disable.
Procedure
(4) Shift Output Each Job
6 • bizhub C650/C550 : It will be displayed only when the optional finisher FS-517/518/608
• bizhub C451
Functions • To set whether to offset each job when paper is printed using the finisher FS-514.
Use • Some paper type may fail to be discharged or get deteriorated loading when large
volume copies are printed using the finisher.
This function is used to print large volume copies when finisher is mounted.
(When this function is set to "No", the paper is discharged without offsetting the paper
to the center of the tray.)
Setting/ • The default setting is Yes.
Procedure
C. Date/Time Settings
Functions • To set the date/time and the time zone to start the clock.
Use • To change settings concerning the date/time.
• This setting should be carried out for set up.
Setting/ • For time zone, set the time difference with the world standard time.
Procedure • Setting range for the time zone: -12:00 to +12:00 (by 30 minutes)
• When the following setting is set to "ON", [Set Data] will be displayed. Touch [Set
Data] and modify the time.
[Administrator Settings] → [Network Settings] → [Detail Settings] → [Time Adjust-
ment Setting]
: Tray 1
: Tray 2
: Tray 1
: Tray 2
Enable
is mounted.
: It will be displayed only when the optional finisher FS-517/608, FS-
519 or the optional job separator JS-504 is mounted.
"Yes"
8. Utility Mode
"Disable"
No
321
6