Konica Minolta bizhub C650 Service Manual page 1197

8. Mechanical adjustment
[1]
[2]
100
[1]
A07RF3C555DA
[3]
[4]
A07RF3C554DA
Field Service Ver. 7.0 Jun. 2008
14. Install the stapler positioning jig [1]
onto the cartridge setting section.
15. Rotate the gears [1] of the staplers
downward and adjust the clinchers to
the positions where two pins [2] of
the stapler positioning jigs are
inserted into the positioning holes [4]
of the clinchers [3], and then rotate
the gears [1] downward further to
fully insert the pins into the position-
ing holes.
NOTE
• Be sure to rotate the gears of the
staplers carefully because the pins
of the stapler positioning jigs may
be clogged if they are inserted forc-
edly.
16. Tighten four screws that were loos-
ened in step 13.
17. Rotate the gears of the staplers
upward to pull out the pins of the jig
from the positioning holes of the
clinchers, and then lift up and
remove the jig.
18. Replace the cartridge.