Table of Contents
Advertisement
Configuring the HP AdvanceStack Internet Router
Configuring the Router for the First Time
Configuring Ethernet or VG Interfaces
It is necessary to decide and configure the network protocols you want to
support on the LAN interface.
1.
2.
N O T E
If you configure for Ethernet and the router module is plugged into a VG
device, you must reconfigure the router module for VG to operate properly.
Configuring the Synchronous Serial Interfaces
The synchronous serial interfaces are configured to allow connection to
WANs. After the Ethernet port on your router has been configured, take the
following steps to configure the synchronous serial interfaces:
1.
3-8
Press Return to configure the LAN interface:
Configuring interface Ethernet0:
(or VG0 depending on what device the router module has been
attached to)
Is this interface in use? [yes]:
Determine which protocols you want to support on the LAN interface and
enter the appropriate responses. In the following example, the system is
configured for IP, AppleTalk, and IPX:
Configure IP on this interface? [yes]:
IP address for this interface: 172.16.72.1
Number of bits in subnet field [8]: 8
Class B network is 172.16.0.0, 8 subnet bits; mask is
255.255.255.0
Configure AppleTalk on this interface? [no]: yes
Extended AppleTalk network? [no]: yes
AppleTalk starting cable range [0]: 3
AppleTalk ending cable range [1]: 3
AppleTalk zone name [myzone]:
AppleTalk additional zone name: otherzone
AppleTalk additional zone name:
Configure IPX on this interface? [no]: yes
IPX network number [1]: B001
Press Return or enter yes to configure serial port 0:
Configuring interface Serial0:
Is this interface in use? [yes]:
Advertisement
Table of Contents
