Removing/Cleaning The Moistener Wick And Holder - Pitney Bowes SV62214 Operator's Manual

Removing and Cleaning the Moistener Wick and Holder
This procedure assumes you have done steps 1 to 7 from
i NOTE:
the previous "Removing and Cleaning the Moistener Brush" section.
1. Pull up and remove the holder and wick from the moistener as
shown here.
2. Separate wick from metal holder, clean the wick in plain water,
and rinse thoroughly.
3. Place the wick back in the hold er.
4. Reinstall the wick and holder assembly into moistener.
5. Reinstall the moistener. Push down on the blue re lease lever on
the moistener.
6. Slide the moistener back onto the machine. You should hear a
click as it engages.
SV62214 Rev. A
Holder
Wick
Release
Lever
10 • Maintenance
10-7