Maintaining the Moistener (cont'd)
Cleaning the Shield and Wick (DM400c)
1.
Open the feeder access cover
and remove the moistener bottle.
Leave the moistener bottle out
until instructed to replace it.
2.
Remove the stripper blade and
brush assembly.
3.
Pull the moistener tank straight
out towards you. Gently lift the
tank up and out.
IMPORTANT:
The moistener tank may be full
of E-Z Seal
If so, you can pour the solution
back into the moistener bottle,
or drain the tank into a recep-
tacle.
4.
Pull up and remove the shield
and wick from the moistener tank.
5.
Separate wick from the shield.
Clean the wick in plain water, and
rinse thoroughly.
NOTE:
i
and shield if they cannot be
cleaned thoroughly.
6.
Place the wick back into the shield.
7.
Push the wick and shield back into moistener tank.
8.
Slide the tank back in place.
9.
Replace the stripper blade and brush assembly by pushing up
on the release lever and sliding the assembly back on its track
until it snaps into position.
10. Replace the moistener bottle and close the feeder access
cover.
SV62261 Rev. A
sealing solution.
®
Replace the wick
12 • Maintenance
Moistener
Tank
Pull here to remove tank
Shield
and Wick
Shield
Wick
12-9