Display Server Configuration/Status Information - Sun Microsystems Sun SPARC Enterprise M3000 User Manual

Note – To obtain the data of exhaust air using the SNMP agent function, install the
latest XSCF extension MIB definition file to the SNMP manager. For details on
obtaining the XSCF extension MIB definition file, see
Note – The amount of power consumption and exhaust air may not be indicated
correctly in the MIB information, in the showenvironment power,
showenvironment air commands output, and on the XSCF Web in the following
cases; and you should wait for one minute and check the value again.
- During the server powering on or powering off, or for a while after the power-on
or power-off complete
- During the active replacement of power supply unit, or for a while after the active
replacement complete
4.1.2

Display Server Configuration/Status Information

■
●
Use the showhardconf(8) command to check the status of a device.
XSCF> showhardconf
SPARC Enterprise xxxx;
:
The status information of each device is as below.
■
■
■
4-6 SPARC Enterprise Mx000 Servers XSCF User's Guide • August 2009
Command operation
+ Serial:PP20605005; Operator_Panel_Switch:Locked;
+ Power_Supply_System:Single; SCF-ID:XSCF#0;
+ System_Power:On; System_Phase:Cabinet Power On;
Domain#0 Domain_Status:Powered Off;
MBU_B Status:Normal; Ver:0101h; Serial:7867000282 ;
CPU/Memory board unit / Motherboard unit information
Unit number, status, version, serial number, FRU number, memory capacity,
and type.
In the M3000 server, the displayed information is CPU status, CPU
operating frequency, CPU type, number of CPU cores, and number of CPU
strands.
CPU module information
Unit number, status, version, serial number, FRU number, CPU operating
frequency, CPU type, number of CPU cores, and number of CPU strands.
Memory information
"Preface" on page xvii.