Sun Microsystems Sun SPARC Enterprise M3000 User Manual page 64

Before attempting to establish a connection to the XSCF and log in from the web
browser window of the XSCF Web, perform
Summary by the XSCF Shell" on page
Administration" on page
Section 2.1.1, "Setup Summary by the XSCF Shell" on page
in this section at
In addition, establish one-to-one communication between the PC and the XSCF
during initial setup.
1. Connect to and log in to XSCF (serial). (Same as Step 1 in
Summary by the XSCF Shell" on page
2. Set the password policy. (Same as Step 2 in
the XSCF Shell" on page
3. Create an XSCF user account, password and privileges. (Same as Step 3 in
Section 2.1.1, "Setup Summary by the XSCF Shell" on page
4. Set the time. (Same as Step 4 in
Shell" on page
5. Make the SSH/telnet settings. (Same as Step 5 in
by the XSCF Shell" on page
6. Confirm the XSCF host public key. (Same as Step 6 in
Summary by the XSCF Shell" on page
7. Install the user public key. (Same as Step 7 in
the XSCF Shell" on page
8. Configure the network. (Same as Step 8 in
XSCF Shell" on page
9. Make the https settings.
• Enable or disable the https.
• Import the web certificate.
To enable https, the XSCF reset is required. Reset the XSCF by using the
rebootxscf(8) command. After the XSCF reset, the XSCF session is disconnected.
Log in again to the XSCF.
Change to the XSCF-LAN connection when you connect the serial cable.
■
10. Establish a connection to XSCF and log in from a web browser.
2-12 SPARC Enterprise Mx000 Servers XSCF User's Guide • August 2009
2-59. If you have already performed
Step 9.
2-3.)
Section 2.1.1, "Setup Summary by the XSCF
2-3.)
2-3.)
2-3.)
2-3.)
Step 1 - Step 8 in
2-3, and enable https in
2-3, start the procedure
2-3.)
Section 2.1.1, "Setup Summary by
Section 2.1.1, "Setup Summary
Section 2.1.1, "Setup
2-3.)
Section 2.1.1, "Setup Summary by
Section 2.1.1, "Setup Summary by the
sethttps(8)
(See Section 2.2.6, "Https Administration"
on page 2-59)
Section 2.1.1, "Setup
Section 2.2.6, "Https
Step 1 to Step 8 in
Section 2.1.1, "Setup
2-3.)