Sun Microsystems Sun SPARC Enterprise M3000 User Manual page 135

<Example> Display of the status when no management information has
been set
XSCF> showsnmp
Agent Status:
Agent port:
System Location:
System Contact:
System Description: Unknown
:
2. Use the setsnmp(8) command to make the SNMP settings.
<Example> Specifying the installation location of the system, system
description, and mail address of the administrator
XSCF> setsnmp -l MainTower21F -c foo@example.com -d DataBaseServer
3. Use the setsnmp(8) command to enable the SNMP agent.
<Example 1>
XSCF> setsnmp enable
<Example 2>
XSCF> setsnmp disable
4. Confirm the SNMP settings.
XSCF> showsnmp
Agent Status:
Agent port:
System Location:
System Contact:
System Description: DataBaseServer
:
Disabled
161
Unknown
Unknown
Enabling the agent.
Disabling the agent.
Enabled
161
MainTower21F
foo@example.com
Chapter 2 Setting Up XSCF 2-83