Specifying Netra Ct Server Fru Id Information - Sun Microsystems Netra CT 820 Administration Manual

Specifying Netra CT Server FRU ID
Information
A field-replaceable unit (FRU) is a module or component that can typically be
replaced in its entirety as part of a field service repair operation.
The Netra CT system FRUs include:
Node boards
I
Distributed management cards
I
Switching fabric boards
I
Power supplies
I
Fan trays
I
Midplane
I
All FRUs except power supplies contain FRU ID (identification) information that
includes FRU manufacturing and configuration data. This information can be
displayed through the distributed management card CLI (see
CT 820 system supports two FRU ID formats:
The Sun FRU ID format, available on the distributed management cards and on
I
the node board (Netra CP2300 cPSB board)
The industry standard IPMI format, available on the midplane, switching fabric
I
boards, fan trays, and third-party node boards conforming to the PICMG 2.9
specification
In addition, you enter certain FRU ID information, through the distributed
management card CLI, that is stored in the midplane. (Note that you can also enter
FRU ID information through the MOH application; refer to the Netra CT Server
Developer's Guide for instructions.) FRU ID information includes:
Allowable plug-in boards (a default exists) and boot devices (a default exists in
I
OpenBoot PROM) for the slots
The system management network configuration (a default exists)
I
System location information, customer data information, and user label
I
information (there are no defaults; these are optional entries)
Some of this information is used by the MOH application to audit board insertions
and prevent misconfigurations, and to display information; some is used by the
system management network.
The format of the information to be specified is:
hostname cli>
12 Netra CT 820 Server System Administration Guide • March 2004
setfru fru_target fru_instance fru_field value
). The Netra
TABLE 2-2