Specifying Or Canceling Prefer For Ntp Server - Sun Microsystems Sun SPARC Enterprise M3000 User Manual

Specifying or Canceling prefer for NTP Server

Command operation
■
1. Use the showntp(8) command to display the prefer settings.
XSCF> showntp -m
prefer : on
2. Use the setntp(8) command to set the prefer.
<Example 1> Specify prefer for NTP server
XSCF> setntp -m prefer=on
Please reset the XSCF by rebootxscf to apply the ntp settings.
<Example 2> Cancel prefer for NTP server
XSCF> setntp -m prefer=off
Please reset the XSCF by rebootxscf to apply the ntp settings.
When you use the setntp(8) command to change the prefer, execute the
rebootxscf(8) command to apply the specified configuration and reset the
XSCF.
3. Use the showntp(8) command to confirm the prefer settings.
XSCF> showntp -m
prefer : off
XSCF> showntp -a
server ntp1.red.com
server ntp2.blue.com
Note – The setting of the prefer by setntp(8) command is supported only on
M3000/M4000/M5000/M8000/M9000 servers that run certain versions of XCP
firmware (beginning with XCP 1082).
Changing Stratum Value for XSCF
Command operation
■
1. Use the showntp(8) command to display the stratum value for the XSCF
network.
XSCF> showntp -s
stratum : 5
2-50 SPARC Enterprise Mx000 Servers XSCF User's Guide • August 2009