Sun Microsystems Sun SPARC Enterprise M3000 User Manual page 370

A Mail Report Was Not Received From XSCF
XSCF does not necessarily report all events. It sends a mail message for each part
■
fault or authentication failure event. Check for the relevant event in the error log,
or use the reference for event logs in
in an event log to be reported.
Use the showemailreport(8) command to check whether the appropriate
■
setting is enabled. If no mail message for this event has been received, check
whether an error mail message has been sent to the error mail recipient, or check
the log of recorded errors.
If a cellular phone is used for receiving mail messages, check the phone settings
■
for any set restriction on receiving messages.
Could Not Access the Top Page of the XSCF Web Function
Use the showhttps(8) command to check whether the setting for XSCF is
■
enabled.
Check whether the entered URL is correct (e.g., whether the "s" in "https" is
■
missing).
Ask the system administrator to check whether access through the IP address that
■
is set is permitted.
Check whether the SSL/TSL function setting of the web browser is enabled.
■
Could Not Display XSCF Web Windows
If XSCF Web windows are not displayed even after login to the system from the
■
top page of XSCF Web, JavaScript may be disabled in the web browser settings.
Enable JavaScript in the browser settings, and retry login.
If pop-up window display is disabled in the web browser settings, XSCF Web
■
windows cannot be displayed. Check the browser settings.
Forgot the Login Password for the XSCF Web
Since XSCF Web authentication is the same as XSCF Shell authentication, see the
■
above
Failed in the First Attempt to Access the XSCF Web Function After
Login
Check whether Cookies are accepted in the web browser settings.
■
D-4 SPARC Enterprise Mx000 Servers XSCF User's Guide • August 2009
Forgot the Login Password for
Appendix B to check whether this is an event
XSCF.