Sun Microsystems Sun SPARC Enterprise M3000 User Manual page 306

1. After a CMU/MBU addition or replacement task and an allocation to a domain
have completed, turn on power to the domain. The update of the OpenBoot
PROM firmware is automatically performed at this time (automatic matching of
versions).
2. Confirm that the firmware version of the target domain agrees with the version
of the XSB firmware allocated to the added or replacement CMU/MBU.
Command operation
■
a. Execute the version(8) command, and confirm it.
XSCF> version -c cmu
DomainID
DomainID
DomainID
Web browser operation
■
a. Display the "Firmware Update" menu.
b. Display the OpenBoot PROM firmware version, and confirm it.
Confirming That the XSCF Firmware is Updated When an XSCF Unit Is
Replaced (There Are Redundant XSCF Units)
a. Operation in State of the Input Power On
1. After doing an XSCF Unit replacement task by using the maintenance guidance
for FEs, the version of the XSCF firmware is automatically set to match the
appropriate firmware.
2. Confirm the firmware version of replaced XSCF Unit.
Note – When a component is replaced in the state of input power off (a cold
replacement), the firmware is not updated automatically. The operator must match
the number of versions.
b. Operation in State of the Input Power Off
The procedures below explain the firmware update when the replacement of one
XSCF Unit is done. When you replace both XSCF Units, see
XSCF Firmware Is Updated When the XSCF Unit Is Replaced (in a System With a
Single XSCF Unit or Both Replacement in a System With Redundant XSCF
Command operation
■
8-18 SPARC Enterprise Mx000 Servers XSCF User's Guide • August 2009
0: 02.09.0000
1: 02.09.0000
:
3: 02.09.0000
"Confirming That the
Units)".