Login To Xscf Shell - Sun Microsystems Sun SPARC Enterprise M3000 User Manual

XSCF Commands (Continued)
TABLE 5-1
Command
prtfru
dumpconfig
restoreconfig
restoredefaults
snapshot
showmonitorlog
showlogs
fmadm
fmdump
fmstat
unlockmaintenance
rebootxscf
who
man
exit
Note – In the M3000/M4000/M5000/M8000/M9000 servers, some of the commands
are not available, depending on the model in use. For the support information of
each command, see the man page or the XSCF Reference Manual.
5.2

Login to XSCF Shell

This section describes how to log in to XSCF. The user can log in to XSCF from an
XSCF-LAN port using either SSH or telnet, or from the serial port.
Description
Displays the FRU-ROM data.
Saves XSCF configuration information to the specified destination.
Restores XSCF configuration information from the specified destination.
Initialises the server or XSCF Unit to the factory shipping state.
Saves log information to the specified destination.
Displays the XSCF monitoring messages on console in real time.
Displays an error log, power log, event log, console log, panic log, IPL log,
temperature/humidity log, and monitor message log.
Monitors or controls the Fault Management Diagnosis Engines (FMDE).
Dumps the fault event log containing FM diagnosis results.
Displays the FMDE status.
Forcibly release the locked status of the XSCF.
Resets the XSCF.
Displays users who login to the XSCF.
Displays the man page of the specified command.
You can see the list of commands by executing man intro.
Ends the XSCF Shell.
Chapter 5 Overview of the XSCF Shell 5-7