Mail Administration; Table 2-18 Mail Administration - Sun Microsystems Sun SPARC Enterprise M3000 User Manual

2.2.10

Mail Administration

The mail report function is used to send an email to the system administrator when
the fault has occurred in the system. This section explains how to set up the XSCF
mail report function.
Note – You should set up the mail configuration so the designated users (platadm,
system administrators, and so on) can receive immediate notification of faults that
occur on the platform or domain.
TABLE 2-18
Mail Administration
TABLE 2-18
Item Description
Display SMTP Displays SMTP server setting
server settings information.
SMTP server Sets the host name or IP address of the
SMTP server.
Authentication If you enable the Authentication, at the
server same time, select the POP authentication
or the SMTP authentication. When you
enable the authentication, specify the
host name or IP address of the
authentication server, user ID, and
password.
Port number Sets the port number of the SMTP server. setsmtp
Reply address Sets the mail address to be specified in
the From: header of a mail message.
lists the settings and the corresponding shell commands.
Shell
Command Remarks
showsmtp
No default value has been
setsmtp
set.
Only one SMTP server can
be specified.
If you specify a host name
for an SMTP server, the
server name must be
resolvable by DNS server.
Default is disable
setsmtp
authentication.
The default port number of
the SMTP server is 25.
To send an error mail when
setsmtp
there is a problem in the
path to the recipient
address from the mail
server, the mail address is
specified.
Chapter 2 Setting Up XSCF 2-91