Sun Microsystems Sun SPARC Enterprise M3000 User Manual page 307

1. Turn on power to the server after completing XSCF Unit replacement task.
2. If the replacement unit and the replaced unit have different versions, a message
is displayed.
3. Confirm the firmware version by using the version(8) command. If you find
an unmatched version of the replaced XSCF Unit, make the replaced XSCF unit
version match the current system version using the flashupdate(8) command.
XSCF> version -c xscf
XSCF#0 (Active )
01.08.0001(Reserve) 01.08.0001(Current)
XSCF#1 (Standby)
01.08.0001(Current) 01.08.0001(Reserve)
XSCF> flashupdate -c sync
4. Confirm the firmware version again.
Note – The sync option is only used at the active XSCF Unit. When the firmware on
the standby site is applied, the XSCF reset of the standby site is done. Then even if
the XSCF session is disconnected, the active XSCF Unit has no impact on.
Web browser operation
■
1. Repeat Step 1 and
the XSCF Web.
2. Display the firmware update menu.
3. Display the XSCF firmware version, and confirm it.
4. If you find an unmatched version of the replaced XSCF Unit, select the XCP
sync. In the window, match the version of the current firmware.
5. Display the XCP version and XSCF firmware version, and confirm them.
Confirming That the XSCF Firmware Is Updated When the XSCF Unit
Is Replaced (in a System With a Single XSCF Unit or Both Replacement
in a System With Redundant XSCF Units)
1. Turn on power to the server after completing the XSCF Unit replacement task.
2. If the replacement unit and the replaced unit have different versions, a message
is displayed.
Step 2 of the Command
Chapter 8 Upgrade of XSCF Firmware and Maintenance
operation. Then login to the XSCF on
8-19