Show Interfaces Transceiver - Edge-Core ES3510MA-DC Management Manual

Table 91: show interfaces switchport - display description (Continued)
Field
Unknown-unicast
Threshold
LACP Status
Ingress/Egress
Rate Limit
VLAN Membership
Mode
Ingress Rule
Acceptable Frame
Type
Native VLAN
Priority for
Untagged Traffic
GVRP Status
Allowed VLAN
Forbidden VLAN
802.1Q-tunnel
Status
802.1Q-tunnel
Mode
802.1Q-tunnel
TPID
This command displays identifying information for the specified transceiver,
show interfaces
as well as the temperature, voltage, bias current, transmit power, and
transceiver
receive power.
S
YNTAX
D
EFAULT
Shows all SFP interfaces.
C
OMMAND
Privileged Exec
Description
Shows if unknown unicast storm suppression is enabled or disabled; if
enabled it also shows the threshold level
Shows if Link Aggregation Control Protocol has been enabled or disabled
(page 742).
Shows if rate limiting is enabled, and the current rate limit
Indicates membership mode as Trunk or Hybrid
Shows if ingress filtering is enabled or disabled
Shows if acceptable VLAN frames include all types or tagged frames only
(page 834).
Indicates the default Port VLAN ID
Indicates the default priority for untagged frames
Shows if GARP VLAN Registration Protocol is enabled or disabled
(page 828).
Shows the VLANs this interface has joined, where "(u)" indicates
untagged and "(t)" indicates tagged
Shows the VLANs this interface can not dynamically join via GVRP
(page 828).
Shows if 802.1Q tunnel is enabled on this interface
Shows the tunnel mode as Normal, 802.1Q Tunnel or 802.1Q Tunnel
Uplink (page
Shows the Tag Protocol Identifier used for learning and switching packets
(page 844).
show interfaces transceiver [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: SFP ports 9-10)
S
ETTING
M
ODE
– 733 –
C
HAPTER
(page
(page 837).
(page
842).
| Interface Commands
27
727).
(page 761).
(page 836).
(page 835).
(page 866).
834).
(page 841).