Hdpii Process Flows (In Table Format); Reviewing The Hdpii Boot-Up Sequence - HID HDPii User Manual

Caution: This device is electrostatically sensitive. It may be damaged if
exposed to static electricity discharges.
Information that raises potential electrostatic safety issues is
indicated by a warning symbol (as shown to the left).
•
To prevent equipment or media damage, refer to the
following safety messages before performing an operation
preceded by this symbol.
•
To prevent equipment or media damage, observe all
established Electrostatic Discharge (ESD) procedures while
handling cables in or near the Circuit Board and Printhead
Assemblies.
•
To prevent equipment or media damage, always wear an
appropriate personal grounding device (e.g., a high quality wrist
strap grounded to avoid potential damage).
•
To prevent equipment or media damage, always remove the
Ribbon and Cards from the Printer before making any repairs,
unless otherwise specified.
•
To prevent equipment or media damage, take jewelry off of
fingers and hands, as well as thoroughly clean hands to remove
oil and debris before working on the Printer.

HDPii Process Flows (in Table format)

Reviewing the HDPii Boot-up Sequence

Please carefully review this step-by-step process.
Step Process
1 The Card Feed Stepper turns ON (to check for a card in the card path).
2 The Film transfer take-up Motor turns ON to take up any slack in the film.
3 The Print Headlift turns until head up position is returned from Headlift Sensor.
4 The Print Ribbon moves forward until it finds the yellow panel, pauses,
advances to magenta, then backs up to yellow (the Ribbon Sensor detects the
color of the Ribbon).
5 The Transfer Film advances forward two panels from supply (advances until
the Print Film Sensor senses two marks on the Film).
6 The Transfer Film advances forward one panel from supply (advances until the
Print Film Sensor senses 1 mark on the Film).
HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
10