Accessing The Network Setup Menu; Saving Addresses - HID HDPii User Manual

Follow the procedure provided below.
Step Procedure
1 See the Accessing the Network Setup Menu procedure to access the
Network Settings menu (Options ->Menu -> Next -> Network Settings).
2 Select Next on the LCD to view the ANEG: menu entry.
3 Press the Change button to change the auto negotiation setting for the
Printer, which will rotate between the following:
• ANEG: AUTO: Allows the auto negotiation between the Printer and the
host Ethernet interface.
• ANEG: Full Dup: Forces the full duplex communications between the
Printer and the host Ethernet interface.
• ANEG: Half Dup: Forces the half duplex communications between the
Printer and the host Ethernet interface.
4 If you change the setting, you will be prompted to reboot the Printer.

Accessing the Network Setup Menu

Step Procedure
1 Apply power to the Printer.
2 Ensure that the Printer is connected to your network.
3 Wait up to one (1) minute to allow the Printer to configure the IP address.
4 Select Options on the LCD.
5 Select Menu on the LCD.
6 Select the Next button on the LCD until the Network Settings menu entry
appears.
7 Press Select when Network Settings appears on the LCD.

Saving addresses

Step Procedure.
1 See the Accessing the Network Setup Menu procedure (above) to access
the Network Settings menu:
HDPii High Definition Card Printer/Encoder User Guide
Options > MENU -> Next -> Network Settings
L001130 Rev 1.4
149