HID HDPii User Manual page 78

High definition card printer/encoder
Table of Contents

Advertisement

capacity.
Printing Error
An error was detected during
printing.
(PC Error Message
No. 107)
Reboot Required
Unspecified system error
detected by the Printer
(PC Error Message
Firmware.
Nos. 9, 65, 67, and
163)
Reinsert Ribbon
The Ribbon must be
reinserted for proper
(PC Error Message
functioning of the Printer.
No. 141)
Remove Card
A card is jammed in the Print
Station or card flipping area
(PC Error Message
of the Printer.
No. 68)
Remove Ribbon
The print Ribbon is not
installed properly or has
(PC Error Message
been damaged.
No. 139)
Ribbon Break/Jam
The Ribbon is not able to
find the next panel correctly.
(PC Error Message
Check for jams/breaks.
No. 99, 108, and
109)
Ribbon Low
The print Ribbon will soon
run out.
(PC Error Message
No. 92)
Ribbon Miscue
The Ribbon is not able to
find the next panel correctly.
(PC Error Message
Check for jams/breaks.
No. 97)
Ribbon Out
The print Ribbon has run
HDPii High Definition Card Printer/Encoder User Guide
Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Reinsert the Ribbon or press
Resume.
Clear the jam and press
Cancel.
Verify the correct Ribbon is
installed in the Ribbon
Cartridge.
Remove it and replace it with
the correct Ribbon.
If jammed, clear the jam. If
broken, repair by taping the
Ribbon back on to the take-up
core.
Press Resume to continue or
Cancel to abort.
If printing a large number of
cards, replace the Ribbon now
or monitor the Printer until the
Ribbon is gone and install a
new Ribbon.
If jammed, clear the jam. If
broken repair by taping the
Ribbon back on to the take-up
core.
Press Resume to continue or
Cancel to abort.
Install a new Ribbon and press
L001130 Rev 1.4
78

Advertisement

Table of Contents
loading

Table of Contents