HID HDPii User Manual page 73

No. 46)
E-Card Encoder A problem was detected
Startup Error during Printer start-up.
(PC Error Message
No. 141)
E-Card Startup Error A problem was detected
during Printer start-up.
(PC Error Message
No. 141)
EEPROM Corrupt EEPROM restored with
factory default values.
(PC Error Message
Nos. 38, 39, 40, and
144)
Ejecting Card The card has been ejected
already.
(PC Error Message
No. 72)
Empty Reject Bin The reject bin is full.
(PC Error Message
No. 265)
Failed To Initialize A problem was detected
during Printer start-up.
(PC Error Message
No. 141)
Film Align Error The film is not able to move
correctly. Check for
(PC Error Message
jams/breaks.
Nos. 26 and 176)
Film Break/Jam The film is not able to move
correctly. Check for
(PC Error Message
jams/breaks.
HDPii High Definition Card Printer/Encoder User Guide
Reset the Printer and try
again. If this problem persists,
call for technical assistance.
Reset the Printer and try
again. If this problem persists,
call for technical assistance.
If changes were, then go into
the setting values and reset
these numbers.
Click OK to clear the
message. The user might
want to know that a card has
been sent to the reject bin, or
out of the Printer, and is either
incomplete or posses a
security risk if not disposed of
properly.
Remove the large number of
rejected cards from the reject
bin.
Click OK to clear the
notification message. (Note:
In some cases, rejected cards
are incomplete or pose a
security risk, and should be
disposed of properly.)
Reset the Printer and try
again. If this problem persists,
call for technical assistance.
Check for obstruction. If the
problem persists, call for
technical assistance.
Check for obstruction. If the
problem persists, call for
technical assistance.
L001130 Rev 1.4
73