HID HDPii User Manual page 53

Use this procedure to adjust the film if it is tracking toward the
GRAY Flange
The film placement on the take-up spool should mirror the position of the film on the supply
spool.
If the film is biased on the take-up spool toward the GRAY flange adjust the peel bar by
turning the adjustment screw in the clockwise direction.
(Gray flange)
Step 1: Install a new roll of transfer film prior to making any adjustment.
NOTE: Adjustment cannot be done with used material.
Step 2: Using a flat blade screwdriver turn the adjustment screw ¼ turn clockwise.
Step 3: Print 10 cards and verify film is tracking straight from supply spool to take-up spool.
If not, repeat step 2 & 3.
HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
53