HID HDPii User Manual page 72

No. 159)
Calibrate Ribbon The print Ribbon Sensor is
out of calibration.
(PC Error Message
Nos. 128 and 170)
Card Feed Stop The Front Cover was
opened. This caused the
(PC Error Message
card transfer to stop OR the
No. 137)
pause button was selected.
Card Jam A card is jammed in the Print
Station or card flipping area
(PC Error Message
of the Printer.
Nos. 82, 112, and
200)
Card Jam: Prox A card is jammed in the
PROX card encoding area of
(PC Error Message
the Printer.
No. 86)
Card Jam: Smart A card is jammed in the
smart card encoding area of
(PC Error Message
the Printer.
No. 85)
Card Jam: Trans Card became jammed in
Printer during transfer.
(PC Error Message
No. 83)
Card Not Found Card cannot be found in the
Printer.
(PC Error Message
No. 69)
Check Film The film is not able to move
correctly. Check for
(PC Error Message
jams/breaks.
No. 244)
Clean Printer For best Printer
performance, replace the
(PC Error Message
Cleaning Roller Tape
No. 71)
and clean the Printer's Feed
Rollers and Printhead at this
time.
Cover is Open The Cover was left open.
(PC Error Message
HDPii High Definition Card Printer/Encoder User Guide
Select Cancel and then
perform the Ribbon calibration
procedure.
Press Resume or Cancel.
Clear the jam.
Clear the jam.
Clear the jam.
Clear the jam.
Verify card not jammed in
Printer and select Cancel.
Check for obstruction. If the
problem persists, call for
technical assistance.
See the appropriate Cleaning
procedures in this document.
Ensure that the Cover is
properly closed.
L001130 Rev 1.4
72