HID HDPii User Manual page 77

No Mag Module MAG encoding job sent to
Printer without MAG
(PC Error Message
encoder.
No. 31)
You are trying to send
encoding data, but the
Printer is not configured with
this Encoder type.
No MiFare Encoder You are trying to send
encoding data, but the
(PC Error Message
Printer is not configured with
No. 203)
this Encoder type.
No Prox Encoder You are trying to send
encoding data, but the
(PC Error Message
Printer is not configured with
No. 32)
this Encoder type.
No Ribbon No Ribbon is installed in the
Printer.
(PC Error Message
OR
No. 25)
Ribbon RFID tag is bad.
No Smart Encoder You are trying to send
encoding data, but the
(PC Error Message
Printer is not configured with
No. 33)
this Encoder type.
Output Hopper Full The Sensor detects when
the Output Hopper has been
filled to prevent more cards
from printing and causing a
jam.
Output Hopper Open The Sensor detects when
the Output Hopper has been
opened. When the Hopper
is opened, cards will not
eject from the Output (to
ensure cards do not eject
into the chassis).
Reject Output The Sensor detects that the
Hopper number of cards rejected is
getting close to the 30-card
HDPii High Definition Card Printer/Encoder User Guide
To cancel, click on Cancel
Print.
To cancel, click on Cancel
Print.
Install the correct Ribbon and
press the Resume button
located on the Printer's LCD
display.
To cancel the print, press the
Cancel Print button from the
Driver's display dialog and the
Cancel button located on the
Printer's LCD display.
To cancel, click on Cancel
Print.
Check the Hopper and remove
cards as needed. Close the
Output Hopper. Press the
Resume button.
Close the Output Hopper.
Press the Resume button.
L001130 Rev 1.4
77