HID HDPii User Manual page 74

No. 158)
Film Low The HDP film will soon run
out.
(PC Error Message
No. 156)
Film Out The HDP film has run out.
(PC Error Message
Nos. 156 and 157)
Film: Wrong Material The HDP Film is not installed
properly or has been
(PC Error Message
damaged.
No. 173)
Flipper Jam A card is jammed in the card
flipping area of the Printer.
(PC Error Message
Nos. 74 and 199)
Head Loading An unrecoverable error has
occurred during printing.
(PC Error Message
No. 111)
Head Resistance The EE setting in Driver for
head resistance is out of
(PC Error Message
range.
No. 6)
HDPii High Definition Card Printer/Encoder User Guide
If printing a large number of
cards, replace the Film now or
monitor the Printer until the
Film is gone and install a new
Film.
Install a new roll of film and
press Resume to continue or
Cancel to reset.
Verify the correct film is
installed in the film Cartridge.
Open the Printer's Flipping
Module Cover.
Clear any cards in the Flipping
Module by opening the
Printers Cover and using the
Forward and/or Back buttons
located on the Printer's Front
Cover.
Ensure that the Output Module
can rotate freely. Close the
Printer's Flipping Module
Cover.
Press the Resume button on
the Printer's Front Cover to
continue printing.
To cancel the print, press the
Cancel Print button from the
Driver's display dialog.
Reset the Printer and try
again. If this problem persists,
call for technical assistance.
Enter a value for head
resistance in the EE settings in
the Driver.
Reset the correct value
according to the steps in the
Troubleshooting Section.
If this problem persists, call for
L001130 Rev 1.4
74