Telnet Command Line Interface; Initiating A Telnet Session; Reviewing The Telnet Command Table - HID HDPii User Manual

Telnet Command Line Interface

Initiating a Telnet Session

This procedure shows how to initiate a Telnet session from a PC in order to access the
Telnet services provided by the Printer.
Description
Initiating a Follow these instructions to issue Telnet commands.
Telnet
1. Identify the IP address of your Printer. (Note: See Switching to the
session
Automatic IP Address Mode
Mode.)
2. Initiate a Telnet session from a DOS window on your PC. At the DOS
prompt, enter telnet [IP Address]
•
Example: C:\>telnet 192.168.11.12
•
All Telnet responses from the Printer will then be displayed in the
Telnet session on the PC.
•
All commands entered will be sent to the Telnet client in the
Printer.
3. Enter "help" or "?" to get an on-window list of supported Telnet
commands.

Reviewing the Telnet Command Table

The following table describes available Telnet commands. (Note: You can enter partial full-
word commands: the Printer will respond with additional help. For example, you can enter
"list", and the Printer will respond with all subcommands to the list command.)
Telnet Command
?
HDPii High Definition Card Printer/Encoder User Guide
Switching to the Automatic IP Address
Command Purpose
Display help for Telnet
L001130 Rev 1.4
Command Format
?
104