Reviewing The Sample String - HID HDPii User Manual

•
In some cases, these specific characters are automatically added to the string of track
data by ID software applications.
•
In most cases, the user must carefully add these characters to the string of Magnetic
Track data. If these characters are not added to the track data, the text intended for the
Magnetic Track will appear as printed text on the card.
•
To avoid this, track information must be entered as described below.
Step Procedure
1 When entering track data, the ~ (tilde) character is entered first, followed by
the track number (1, 2 or 3) on which the data should encode. This is
followed by the data to be encoded.
•
The first character of this data string must be the track's specific Start
Sentinel (SS) and the last character must be the specific End Sentinel
(ES).
•
The characters or data in between the SS and ES can include all of the
valid characters specific to each track.
•
The number of these characters, however, is limited by each track's
maximum character capacity.
•
When segmenting track data, the appropriate Field Separator (FS) must
be used. The table below shows the SS, ES, FS and the valid characters
defined for each track.

Reviewing the Sample String

•
Track 1: ~1%JULIEANDERSON^1234567890?
•
Track 2: ~2;1234567890987654321?
•
Track 3: ~3;1234567890987654321?
HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
219