HID HDPii User Manual page 84

Wrong Ribbon An incorrect Ribbon has
Installed been installed, or a driver
setting is incorrect.
No Ribbon Installed No Print Ribbon is
installed in the Printer.
Ribbon Out The Print Ribbon installed
in the Printer is empty.
Ribbon Break/Jam A Ribbon break/jam has
been detected inside the
Printer.
HDPii High Definition Card Printer/Encoder User Guide
from the Driver's display dialog, or
the Cancel button located on the
Printer's LCD display.
Check that the Ribbon is correct
for the Printer and job. Press the
Resume button located on the
Printer's LCD display to continue
printing.
To cancel the print, press the
Cancel Print button from the
Driver's display dialog, or the
Cancel button located on the
Printer's LCD display.
Install the correct Ribbon and
press Resume on the LCD
display.
Install a new Ribbon and press
Resume on the LCD display.
The Printer has determined that
the installed Ribbon has either
jammed or broken.
a. Open the Printer Cover and
remove the Print Ribbon. If
Ribbon is jammed, remove
jam and tighten Ribbon.
b. Clear any cards in the Printer
by using the Forward and/or
Back buttons located on the
Printer's LCD display.
c. Tape the ends of the Ribbon
together and wind any excess
onto the Take-up Spool of the
Print Ribbon.
d. Re-install the Print Ribbon,
close the Printer Cover and
press the Resume button
located on the Printer's LCD
display to continue printing.
e. To cancel the print, press the
Cancel Print button from the
Driver's display dialog and the
Cancel button located on the
Printer's LCD display.
L001130 Rev 1.4
84