Using The Transfer Tof Adjustment Option - HID HDPii User Manual

Using the Transfer TOF Adjustment Option

Follow this instruction.
Step Procedure
1 Set the Transfer TOF to –40.
2 Print the alignment card self-test. (Note: The front edge should look like
Figure 280.1.)
3 Determine which TOF grid line is closest to the edge of the card.
4 Align the leading edge of the print to the leading edge of the card. Follow this
instruction:
• Adjust the Transfer TOF setting up or down by the number (located directly
to the right of the line found in the previous step).
• Determing this setting by using the (+/-) orientation arrows located at the
upper and lower left sections of the card.
5 Print the alignment card self-test. (Note: The leading edge should look like
Figure 280.2.)
6 Follow this instruction:
a. If the card is not aligned properly, make any additional changes necessary
using the Print TOF setting.
b. Print another alignment card.
c. Repeat the process as needed.
HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
269