HID HDPii User Manual page 153

Printer?
Can I print from my PC to
multiple Ethernet Printers?
Can multiple PC's print to my
Ethernet Printer?
Can I print from my PC to an
Ethernet Printer on a
different network segment?
Can I use Fargo IP-Tracer to
locate Printers on a different
network segment?
How do I upgrade the Printer
Firmware in my Ethernet-
enabled Printer?
How do I upgrade the Print
Server Firmware for my
HDPii Printer?
What is the default User
HDPii High Definition Card Printer/Encoder User Guide
functioning properly.
Select Info, then select Next several times until the IP address
is shown.
Choose "Local printer..." unless a shared network printer is to
be installed on a print server.
Use the Windows "Add Printer Wizard" to create a printer
instance to communicate to the printer at the new IP address.
If the printer port is not listed as an existing port then a new
"HDPii TCP/IP Card Printer Port" must be created and
configured to communicate to the printer at the proper IP
address.
See the appropriate Windows documentation for additional help.
Yes. Each PC must install the Printer Driver software for the
specific Fargo Ethernet-enabled Printer and connect to the
intended Printer, using the correct IP address.
Yes. If you know the IP address of the Printer on any segment
of your network, you will be able to print to it.
No. The IP-Tracer can only locate Fargo-compatible Printers
located in the same network segment (as the PC running IP-
Tracer).
Follow this procedure.
1.Run the Fargo Workbench Printer Utility from the start menu:
Go to the Start -> Programs -> Fargo -> Fargo Workbench
Printer Utility.
2.Select the Fargo Printer to upgrade from the drop-down box.
3.Go to the Firmware Updates tab.
4.If you need to download the update file from the Internet,
select the Download Firmware button.
5.Choose the update file with the Select Firmware button.
6.Put your Printer into the upgrade mode. See the instructions
for your specific Fargo Printer.
7.Select the Send Firmware button.
Since the Print Server is integrated into the main print Firmware
on the HDPii, there is not a separate Firmware upgrade for the
Printer Server. (Note: Therefore, the upgrades are done with
the main Printer Firmware.)
The default passwords are blank (i.e., an empty string).
L001130 Rev 1.4
Formatted: Bullets and Numbering
153