HID HDPii User Manual page 76

Mag Encoder Startup A problem was detected
Error during Printer start-up.
(PC Error Message
No. 63 and 141)
Mag Verify Error Print could not verify MAG
write.
(PC Error Message
OR
No. 30)
The magnetic stripe was not
encoded properly.
Multiple Feed Multiple cards were fed into
the Printer.
(PC Error Message
No. 70)
No E-card Encoder You are trying to send
encoding data, but the
(PC Error Message
Printer is not configured with
No. 202)
this Encoder type.
No Film Film is not installed in
Printer.
(PC Error Message
OR
No. 28)
Film RFID tag is bad.
No Flip Module Two-sided job sent to a one-
sided Printer.
(PC Error Message
No. 201)
No iClass Encoder You are trying to send
encoding data, but the
(PC Error Message
Printer is not configured with
No. 177)
this Encoder type.
HDPii High Definition Card Printer/Encoder User Guide
Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Check the Cards and click on
Cancel Print.
Remove all cards and try
again.
You are trying to send
encoding data, but the Printer
is not configured with this
Encoder type.
Install the Film and press
Resume.
To cancel the print, press the
Cancel Print button or the
Cancel button located on the
Printer.
Verify the Printer has flipper
capabilities via the LCD Menu.
If Output capabilities are
present, ensure that the Print
Both Sides option in the
Driver is set correctly.
Press the Resume button on
the Printer's Front Cover to
continue printing.
To cancel the print, press the
Cancel Print button from the
Driver's display dialog.
You are trying to send
encoding data, but the Printer
is not configured with this
Encoder type.
L001130 Rev 1.4
76