HID HDPii User Manual page 79

(PC Error Message out.
No. 91, 100 and 101)
Ribbon Tension The Ribbon tensions may be
out of range.
(PC Error Message
No. 98)
Ribbon: Wrong The print Ribbon is not
Material installed properly or has
been damaged.
(PC Error Messages
No. 93, 122, and
172)
System Fault Unspecified system error is
detected by the Printer
(PC Error Message
Firmware.
No. 164)
Unable to Feed The Printer is unable to feed
a card from the Card
(PC Error Message
Cartridge.
Nos. 14 and 81)
Utility Error Command resulted in an
error.
(PC Error Message
Nos. 129)
Waiting for Data The Printer has stopped
receiving data from the PC.
(PC Error Message
No. 147)
Wrong Film The print film installed in the
Printer does not match the
(PC Error Message
film type selected in the
Nos. 162 and 163)
Printer Driver.
OR
A Self-test job cannot be
printed with the print media
HDPii High Definition Card Printer/Encoder User Guide
Resume to continue.
Check and adjust the setting
through the TOOLBOX under
the Advanced Settings tab.
If this problem persists, call for
technical assistance. Press
Resume to continue or cancel
to abort.
Verify the correct Ribbon is
installed in the Ribbon
Cartridge.
Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Verify there are cards in the
Card Cartridge.
Verify cards are not stuck
together or jammed, and they
are the correct thickness..
See Resolving the
Communications Errors.
Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Replace film in Printer with
type specified in the Driver.
A reboot is required.
L001130 Rev 1.4
79