HID HDPii User Manual page 75

Head Sensor Error The Printhead Temperature
Sensor is not functioning or
(PC Error Message
is not connected properly.
No. 8)
OR
The Printhead is not cooling
properly.
Head Voltage Error A hardware fault has
prevented setting the correct
(PC Error Message
Printhead voltage.
Nos. 103 and 105)
Headlift Error This is a problem with the
Printhead Lift or Transfer
(PC Error Message
Roller Headlift.
Nos. 102, 103, 104,
and 105)
Heater Error The Transfer Heater Roller is
too hot.
(PC Error Message
No. 161)
Invalid Film An unauthorized film is
installed in the Printer.
(PC Error Message
Nos. 94, 95, 96, 164,
165, and 166)
Invalid Password Printing disabled at this time.
(PC Error Message
No. 136)
Invalid Ribbon An unauthorized Ribbon is
installed in the Printer.
(PC Error Message
No. 93)
Job Data Error The print data sent to the
Printer is corrupt or has been
(PC Error Message
interrupted.
No. 106)
Mag Encoder Paused The Magnetic Encoder is in
a pause state.
(PC Error Message
No. 143)
HDPii High Definition Card Printer/Encoder User Guide
technical assistance.
If the problem persists, call for
technical assistance.
Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
Get the correct Film from your
dealer.
Press Cancel to abort this
print job and then check
security settings at host
computer.
Get the correct Ribbon from
your dealer.
Reset the Printer and try
again.
If this problem persists, call for
technical assistance.
L001130 Rev 1.4
75