Changing To The Static Ip Address Mode - HID HDPii User Manual

Changing to the Static IP Address Mode

Step Procedure
Select the Network link from any web page of the Printer.
1
Select the Use the following IP address radio button, which prepares the
2
Printer to use network settings (that the User has manually set).
These manual settings will then be used the next time the Printer is
rebooted.
3 Enter the network settings which are required for Ethernet communications
from within the same subnet.
With only these entries the User will be unable to print from a subnet other
than the subnet on which the Printer is connected. These required settings
are the following:
• IP Address
• Subnet Mask
4 Enter the optional network settings for Ethernet communications across a
router from other subnets, as follows:
• Default Gateway
5 Enter the optional network settings for DNS. These are the following:
• DNS Server Address
• DNS Domain Suffix
6 Select the Submit button to save these changes to stored settings in the
memory of the Printer. (Note: These settings will not be lost if the power is
removed from the Printer.)
7 Login as a root User if you are so prompted. (Note: Any change of setting
will only be accepted after you have successfully logged in.)
8 Reboot the Printer to effect this change.
See the Reviewing Web page security procedure (below).
HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
117