Reviewing The Telnet Command Table - HID DTC1000 Ethernet User Manual

Step Procedure
1 Apply power to the Printer.
2 Ensure that the Printer is connected to your network.
3 Wait up to one (1) minute to allow the Printer to configure the IP address.
4 Scroll through the informational messages on the LCD by selecting the INFO
button (the button on the right of the front panel).
5 View the IP address displayed as a dotted quad number.
Example: 168.192.1.1

Reviewing the Telnet Command Table

The following table describes available Telnet commands. (Note: You can enter partial
full-word commands: the Printer will respond with additional help. For example, you can
enter list, and the Printer will respond with all subcommands to the list command.)
Telnet Command
?
help
reset
ping
list all
diff
uptime
sysinfo
DTC1000/4000/4500 Ethernet User Guide – Installation Guide
Command Purpose
Display help for Telnet
commands.
Reset the Ethernet interface for
the Printer/Encoder.
Send a ping command to another
IP address as a test of the
Ethernet interface.
Display all information about this
Printer.
Display all differences between
current and stored network
settings.
Display how long since the
interface was last reset.
Display information about the
Printer (i.e., model, label, contact,
location, Firmware version and
date, and serial number).
Command Format
?
reset
ping <IPADDR>
list all
list diff
list uptime
list sysinfo
L001411 (Rev.1.0) 13