HID HDPii User Manual page 108

Telnet Command
ifc mode
from
Telnet Command
save
load
lpstat
cancel
quit
HDPii High Definition Card Printer/Encoder User Guide
Command Purpose
settings.
Specify the Ethernet
interface mode as:
automatic, full or half duplex;
10 or 100 mHz. (NOTE: 100
mHz. is not supported by the
HDPii).
Set the Ethernet mode
settings from the default or
current settings.
Command Purpose
Save all current settings as
the stored settings in the
permanent memory.
Take the settings from the
stored memory and make
them the current settings.
Display information about
the Printer status.
This includes the status and
device response.
See the Printer web page
description.
Cancel a specific print job
from the print queue.
Stop the current Telnet
session.
L001130 Rev 1.4
Command Format
store ifc mode
auto|10half|10full|100half|1
00full
store ifc from
default|current
Command Format
save
load
lpstat
cancel 10
quit
108