Show L2-Module-Config - Avaya P330 Reference Manual

show l2-module-config

User level: user, privileged, supervisor
Use the show l2-module-config command to display Layer 2 module
configuration.
The syntax for this command is:
show l2-module-config
A shortened example is shown below: the full output shows information on all
the ports.
If this command is to be implemented on a switch other than the stack master, a
session should be opened to the relevant switch.
Example:
Router-N> show l2-module-config
Please be patient.
Gathering and displaying the information might take a
while.
P330-1(super)# !#
!# Upload time:
!# System description:
!# Master position:
!#
!# Module #:
!# Module type, expansion type:
!# Module-CS, expansion-CS:
!# MAC address:
!# Serial #:
!# SW versions - bank A, B, Boot:
!# Number of ports:
!#
!#THERE IS NO LINK AGGREGATION GROUP.
set internal buffering 1 med
!#
!#
Avaya P330 Reference Guide
Chapter 2 Avaya P330 Layer 2 CLI Commands
Unavailable Unavailable
Avaya Inc. - P330
1
1
P333R-LB
3.0
00-40-0d-b9-89-00
4425161
3.12.2 4.0.3 3.3.0
24
115