Ip Access-List-Name - Avaya P330 Reference Manual

Chapter 3 Avaya P330 Layer 3 CLI Commands
ip access-list-dscp trust <policy-list-number>
{untrusted|trust-cos |trust-dscp}
policy-list-
number
untrusted
trust-cos
trust-dscp
Example:
Router-N(configure)# ip access-list-dscp trust 100 trust-
dscp
Done!

ip access-list-name

User level: privileged, supervisor.
Use the ip access-list-name command to set a name for a policy list.
The syntax for this command is:
ip access-list-name <policy-list-number> <name>
<policy-list-number>
<name>
Example:
Router-N(configure)# ip access-list-name 101 morning
If you wish to enter a name which includes spaces, you must enclose the entire
name in quotation marks, for example "new york".
180
A valid id number for a policy list currently defined for the module
(100 - 149)
Forward the packet with priority 0
Forward the packet with its original 802.1p priority (default)
Forward the packet with the maximum priority between 802.1p and
the priority obtained from the DSCP-CoS mapping table
integer (100 - 149)
list name
Avaya P330 Reference Guide